holes. Can also be installed in tapped holes. Blind end version is ideal when receptacle is to be used with structural Provides for retraction of stud assembly to allow opening and closing of equipment without the possibility of jamming or for ultrasonic installation. Integral stud cup protects top panel surface from abrasion. 2600 Series. Not recommended for use with Stud Ejector Springs. Use 2600-SW. Maximum Service Temperatures: Stainless

Ollgaard et al. [ 1] proposed an empirical formula for the load-slip curve of conventional welded stud connectors under continuous loading:turn fasteners are qualified to MIL-F-5591* specifications. Also included are receptacles for fast installation, or In Equations ( 8) and ( 9), is the slip value of welded stud connectors (mm) and stands for the ratio of the loading force to the shear strength of welded stud connectors. damage. Select the ejector spring corresponding to stud assembly series selected. See table for part numbers. A wide choice of general purpose studs and receptacles are available with this series. Certain 2600 and 2700 series Provides convenient means for accurately locating rivet holes with .750 inch spacing relative to stud mounting hole.

Previous researchers have proposed various definitions for the shear stiffness prediction of welded stud connectors. Oehlers and Coughlan [ 2] proposed an empirical equation to calculate the initial shear stiffness of normal stud connectors based on the experimental results, as shown in Equation ( 4). It is adopted by Shim et al. [ 16] to evaluate the shear stiffness of large diameter studs, and the results show that Equation ( 4) gives rather conservative predictions:

Key Benefits

EN 1994-1-1 [ 18] specifies the design strength of one stud connector given by the following equation: where is the diameter of the stud shank (mm), which is specified between 16 mm and 25 mm, is equal to 1.0 when the overall stud height is larger than four times of its diameter, the tensile strength of the stud material is specified no greater than 500 MPa according to EN 1994-1-1 [ 18], the recommended value for the partial factor is 1.25, and other variables have the same meaning with Equation ( 1). RS PRO is our own brand range and brings you a wide range of high-quality, great value products offering you more choice. Trusted by engineers all over the world, every part of every RS PRO product has been rigorously tested against demanding industry standards; they’re only given the RS PRO Seal of Approval if we’re confident of their exceptional quality, which means you can be confident too. Calculation: “G” + .038 = .163 + .038 = .201 Stud Dash Number Selected From Table: -6 Complete Part Number: 2600-6S Stud Dash Number Drill, counterbore, and then tap thread in structure using data from table below. Turn KEENSERTS Insert into tapped hole